Solved

DLink DWL-8200AP Revision B

Posted on 2009-05-03
2
1,104 Views
Last Modified: 2013-11-09
My DLink DWL-8200AP Revision B does not have an IP address after firmware 2.10 upgrade. I upgraded two of these AP using a wired connection and have the same problem both devices.

Everything seems fine during the firmware upgrade. It's just that the AP no longer has an IP so you can not connect to it to configure once the firmware upgrade is complete. Tried to reset the device by holding the reset button for 15sec and can not access it using the 192.168.0.50 address.
0
Comment
Question by:BMStealth
2 Comments
 
LVL 30

Expert Comment

by:IanTh
ID: 24293810
just set a client to dhcp and then reboot once rebooted go to command and typr ipconfig /all then you will see the gateway ip address near the bottom thats the ip address of your router
0
 
LVL 1

Accepted Solution

by:
BMStealth earned 0 total points
ID: 24300337
Sorry if I didn't not give out enough information. By default, these AP do not have DHCP service turned on. The default setting is 192.168.0.50. I gave my laptop wired NIC an IP of 192.168.0.51 and connected it to the AP to upgrade the Firmware. After waiting 15min to for the firmware upgrade to finish, I tried to reconnect to the AP with no success. Did not respond to pings at all. I tried to reset the device by holding the reset button for 15sec and still no luck.

Just to confirm, I tested your suggestion and It's just as I though. It did not help. Thanks for the suggestion though.

I called DLink today and after going over with I did to try and trouble shoot, they are just going to send me two replacement AP since both AP failed after the firmware upgrade.
0

Featured Post

Connect further...control easier

With the ATEN CE624, you can now enjoy a high-quality visual experience powered by HDBaseT technology and the convenience of a single Cat6 cable to transmit uncompressed video with zero latency and multi-streaming for dual-view applications where remote access is required.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
Surface Pro 4 keyboard not responding 4 57
Linksys 4 port wireless router 62 60
How to Link NetGear wireless AC-1200 router to Sonicwall 3600 13 59
WLC and radius 4 9
DECT technology has become a popular standard for wireless voice communication. DECT devices are not likely to be affected by other electronic devices and signals because they operate in a separate frequency-band.
This paper addresses the security of Sennheiser DECT Contact Center and Office (CC&O) headsets. It describes the DECT security chain comprised of “Pairing”, “Per Call Authentication” and “Encryption”, which are all part of the standard DECT protocol.
This Micro Tutorial will show you how to maximize your wireless card to its maximum capability. This will be demonstrated using Intel(R) Centrino(R) Wireless-N 2230 wireless card on Windows 8 operating system.
Viewers will learn how to connect to a wireless network using the network security key. They will also learn how to access the IP address and DNS server for connections that must be done manually. After setting up a router, find the network security…

839 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question