Solved

service control manager 7003 netlogon not start and can not re add to domain

Posted on 2009-05-06
1
552 Views
Last Modified: 2013-12-23
I had a server say called jane.  I replaced it with a new server and called that server jane.  I tried to dcpromo the first jane but would not.  I took it down, upgraded to win2k3 and then dcpromo/forceremoval which gave me a member domain.  I renamed the old server oldjane.  When I try to readd it to the domain it comes up with two errors.

Event ID 7003 service control manager "the net logon service depends on the following nonexistence service: lmHosts" and "the computer browser service depends on the following nonexistence service:lmhosts"

I saw microsoft kb 1518146 said remove tcp/ip and reinstalled.  Only way I could do so was unclick the tc/ip and it removed microsoft  networks.  Shut completely down.  Rebooted.  Reinstalled tcp/ip and microsoft network.  Shut down and rebooted.

Tried readding.  Same error but another message came up that "ane.domain.local" did not exist.

I can see the registry is corrupted but not sure where to go from here.

0
Comment
Question by:jockbir
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 32

Accepted Solution

by:
Kamran Arshad earned 500 total points
ID: 24448222
Hi,

Please read the below comments;

http://eventid.net/display.asp?eventid=7003+&source=
0

Featured Post

Enroll in May's Course of the Month

May’s Course of the Month is now available! Experts Exchange’s Premium Members and Team Accounts have access to a complimentary course each month as part of their membership—an extra way to increase training and boost professional development.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
GPS For Commercial Vehicles 10 75
CISCO WIFI 6 72
how to tell if SMBv1 is enabled on a server or workstation? 3 46
port-forwarding asa 9.5 9 26
#Citrix #Citrix Netscaler #HTTP Compression #Load Balance
In this article, I am going to show you how to simulate a multi-site Lab environment on a single Hyper-V host. I use this method successfully in my own lab to simulate three fully routed global AD Sites on a Windows 10 Hyper-V host.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
This video gives you a great overview about bandwidth monitoring with SNMP and WMI with our network monitoring solution PRTG Network Monitor (https://www.paessler.com/prtg). If you're looking for how to monitor bandwidth using netflow or packet s…

734 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question