Link aggregation

Hi,

I have an cisco 2811 with two nic, how can i do to aggregate this two links to becaume an only redondant port

Thanks
jamillAsked:
Who is Participating?
 
jamillAuthor Commented:
it's work i tried this thank u


But its si possible to do that with ether channel  ?



         -----etherchannel--------((catalyst1))
        |                                                 |
(((router)))                                         |
        |_____etherchannel___((catalyst2))
0
 
Don JohnstonInstructorCommented:
Do what with etherchannel???
0
Ultimate Tool Kit for Technology Solution Provider

Broken down into practical pointers and step-by-step instructions, the IT Service Excellence Tool Kit delivers expert advice for technology solution providers. Get your free copy now.

 
jamillAuthor Commented:
i want to do and etherchannel 802.1Q vlan trunk and using a multichassis configuration is it possible ?

Best regards
0
 
QuoriCommented:
Depends on the switch. If they support stackwise you can, but need stacking cables!
0
 
Don JohnstonInstructorCommented:
Cisco does not support multichassis etherchannel

On the 3750's (using stackwise cables) and 6500 with VSS the multiple chassis becomes a single virtual chassis.
0
 
jamillAuthor Commented:
Hi all

it mean the 2690 series does not support the multi-chassis ?


Regards
0
 
jamillAuthor Commented:
Hi all

it mean the 2960 (lite) series does not support the multi-chassis ?


Regards
0
 
Don JohnstonInstructorCommented:
As previously stated:

Cisco does not support multichassis etherchannel. Unless you've got a 3750 or 6500 with appropriate hardware, then it comes close.


0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.