greekstones
asked on
Cisco ASA VPN with Dynamic Ip address in one site
Hi every body
I have a Cisco ASA at the Main loacation with a static Ip address but now i'm trying to connect my other site via SITE to SITE vpn but the other site has a dynimic ip address ADSL and static ip address is not possible .
Can some one please help me to set up or is there anybody that done this before .
Please send me some sample configuration.
regards.
I have a Cisco ASA at the Main loacation with a static Ip address but now i'm trying to connect my other site via SITE to SITE vpn but the other site has a dynimic ip address ADSL and static ip address is not possible .
Can some one please help me to set up or is there anybody that done this before .
Please send me some sample configuration.
regards.
ASKER
Ok that looks good but
I have cisco asa in one end and a cisco 877W on the other site. the link is PIX to ASA. Do you know how to configure the 877w for the client vpn . I need the router to connect to the asa not the PC client.
regards.
I have cisco asa in one end and a cisco 877W on the other site. the link is PIX to ASA. Do you know how to configure the 877w for the client vpn . I need the router to connect to the asa not the PC client.
regards.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Hi there
i tryed all that but now i can't get connection
my configuration on the router are like this, do i missing something from here. i can't get connectong to asa from my 2800 . but from my laptop i don't have any problems i can connect with no issues with client software..
Virtual-template 1
ip unnumberd fastethernet 0/0.1
crypto ipsec client ezvpn CCM
connect auto
group TESTVPN key cisco
local-address Virtual-Template1
mode client
peer 88.88.88.88
username ntstest password nts
xauth userid mode local
-------------------------- ---------- --
show crypto ipsec client ezvpn
Tunnel name : CCM
Inside interface list: FastEthernet0/1
Outside interface: FastEthernet0/0.1
Current State: VALID_CFG
Last Event: VALID_CONFIG_ENTERED
Save Password: Allowed
Current EzVPN Peer: 88.88.88.88
i tryed all that but now i can't get connection
my configuration on the router are like this, do i missing something from here. i can't get connectong to asa from my 2800 . but from my laptop i don't have any problems i can connect with no issues with client software..
Virtual-template 1
ip unnumberd fastethernet 0/0.1
crypto ipsec client ezvpn CCM
connect auto
group TESTVPN key cisco
local-address Virtual-Template1
mode client
peer 88.88.88.88
username ntstest password nts
xauth userid mode local
--------------------------
show crypto ipsec client ezvpn
Tunnel name : CCM
Inside interface list: FastEthernet0/1
Outside interface: FastEthernet0/0.1
Current State: VALID_CFG
Last Event: VALID_CONFIG_ENTERED
Save Password: Allowed
Current EzVPN Peer: 88.88.88.88
You can setup EasyVPN. Remote sites do not have to have static IP addresses.
http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00805c5ad9.shtml
Regards