Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people, just like you, are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
Solved

Can a cisco 2611XM router handle a t3 NM and 2  t1 interfaces?

Posted on 2009-05-06
1
323 Views
Last Modified: 2012-06-21
I have a spare 2611XM router lying around and want to connect branch offices via ds3 and t1's. Is the 2611 sufficient for this task, or do i need a 2800 router?
0
Comment
Question by:dktt18
1 Comment
 
LVL 50

Accepted Solution

by:
Don Johnston earned 50 total points
ID: 24318466
2611XM maxes out at about 10mbps. A T-3 line is around 45mbps so the router would be a bottleneck.

http://www.cisco.com/web/partners/downloads/765/tools/quickreference/routerperformance.pdf

0

Featured Post

Networking for the Cloud Era

Join Microsoft and Riverbed for a discussion and demonstration of enhancements to SteelConnect:
-One-click orchestration and cloud connectivity in Azure environments
-Tight integration of SD-WAN and WAN optimization capabilities
-Scalability and resiliency equal to a data center

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
How to configure AT&T Netgate with Sonicwall Firewall 24 76
Multiple MPLS Circuits Connecting to LAN 3 43
TL-R470T+ and Cisco ASA 2 21
Public DNS  Vs BGP 20 25
It happens many times that access list (ACL) have to be applied to outgoing router interface in order to limit some traffic.This article is about how to test ACL from the router which is not very intuitive for everyone. Below scenario shows simple s…
How to set-up an On Demand, IPSec, Site to SIte, VPN from a Draytek Vigor Router to a Cyberoam UTM Appliance. A concise guide to the settings required on both devices
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

861 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question