Solved

Netgear DG834 forgotten password

Posted on 2009-05-08
1
560 Views
Last Modified: 2012-06-27
I have a customer who has forgotten the password to there Netgear DG834, is there anyway of getting the config or the password without defaulting the router?
0
Comment
Question by:mistyfly
1 Comment
 
LVL 12

Accepted Solution

by:
Steve earned 250 total points
ID: 24334562
nope.. unless you can guess it, then you'll need to factory reset it to gain access..

To factory reset

Hold in the reset button and power on. Keep holding in for 30sec. Wait until the modem responds. If no response do it again. Hold it down for as long as 1 min.
0

Featured Post

PRTG Network Monitor: Intuitive Network Monitoring

Network Monitoring is essential to ensure that computer systems and network devices are running. Use PRTG to monitor LANs, servers, websites, applications and devices, bandwidth, virtual environments, remote systems, IoT, and many more. PRTG is easy to set up & use.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
Migration from a Juniper to sonicwall issue 4 34
NSD FAIL 2 88
Not able to route between subnets 8 103
2 Gateways (bandwidth) - One domain 7 49
We've been using the Cisco/Linksys RV042 for years as: - an internet Gateway - a site-to-site VPN device - a leased line site-to-site subnet-to-subnet interface (And, here I'm assuming that any RV0xx behaves the same way as an RV042.  So that's …
How to set-up an On Demand, IPSec, Site to SIte, VPN from a Draytek Vigor Router to a Cyberoam UTM Appliance. A concise guide to the settings required on both devices
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

911 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

21 Experts available now in Live!

Get 1:1 Help Now