sabev
asked on
Can't debug .asp in Visual InterDev
Yeah, It's an old project. Problem is, it won't let me debug. If I hover over the BreakPoint I get the error - "The Break Point will not currently be hit. The document is not loaded".
ASP debugging is enabled on IIS.
ASP debuggin is also enabled in the project properties.
I'm really, really stuck here. I have reloaded InterDev and IIS.
Thanks for any help
ASP debugging is enabled on IIS.
ASP debuggin is also enabled in the project properties.
I'm really, really stuck here. I have reloaded InterDev and IIS.
Thanks for any help
ASKER
hmmmm.... No .pdb file is being created. I'm not creating a .DLL here. This is a Web project.
Should a .pdb be created for a Web project?
And I see no Configuration Properties under Project properties. I have six tabs -
General
Master Web Server
Dependencies
Launch
Editor Defaults
Appearance
Thanks! I'm getting pretty desperate.
Should a .pdb be created for a Web project?
And I see no Configuration Properties under Project properties. I have six tabs -
General
Master Web Server
Dependencies
Launch
Editor Defaults
Appearance
Thanks! I'm getting pretty desperate.
My bad, I didn't look that it's a web project.
In your case, try debugging in this way:
http://weblogs.asp.net/scottgu/archive/2007/07/19/vs-2008-javascript-debugging.aspx
In your case, try debugging in this way:
http://weblogs.asp.net/scottgu/archive/2007/07/19/vs-2008-javascript-debugging.aspx
ASKER
Well, it's not .NET.
And when I set a break point like in the link it just says - "The Break Point will not currently be hit. The document is not loaded".
And when I set a break point like in the link it just says - "The Break Point will not currently be hit. The document is not loaded".
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Ask CS for a PAQ and refund of this Q
1. Go to you project Properties and check Configuration Properties -> Build -> Outputs -> Generate Debugging Information setting. It should be set to True.
2. Try to compile in Debug mode with this setting set to True.
3. Run the project.
Good luck!