Want to win a PS4? Go Premium and enter to win our High-Tech Treats giveaway. Enter to Win

x
?
Solved

Cisco privilege levels - defining commands

Posted on 2009-05-11
3
Medium Priority
?
1,181 Views
Last Modified: 2012-05-06
Hi

I wish to give some of our admin guys some basics commands to use on our Cisco 3560 and 3750 switchs to allow them define mac addresses on ports with port security.

I have assigned them level 6 privilege and configured 'configure terminal and 'interface' commands but when I try to add 'switchport' command it does not appear in there list of usable commands and if I use 'switchport port-security mac-address' it does not recognise the command.

Am I able to add this command and how?

Thanks

Beskee

0
Comment
Question by:BESKEE
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
3 Comments
 
LVL 7

Accepted Solution

by:
LANm0nk3y earned 1500 total points
ID: 24356543
0
 

Author Comment

by:BESKEE
ID: 24357404
Thanks LANm0nk3y

The link at least pointed me in the right direction to find my solution. I was not configuring the mode (interface) correctly to the command,

privilege interface level 6 switchport port-security mac-addres

that did the trick, thanks

Beske
0
 
LVL 7

Expert Comment

by:LANm0nk3y
ID: 24357446
You're welcome.  Glad I was able to help.
0

Featured Post

Technology Partners: We Want Your Opinion!

We value your feedback.

Take our survey and automatically be enter to win anyone of the following:
Yeti Cooler, Amazon eGift Card, and Movie eGift Card!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

We've been using the Cisco/Linksys RV042 for years as: - an internet Gateway - a site-to-site VPN device - a leased line site-to-site subnet-to-subnet interface (And, here I'm assuming that any RV0xx behaves the same way as an RV042.  So that's …
Creating an OSPF network that automatically (dynamically) reroutes network traffic over other connections to prevent network downtime.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

610 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question