Solved

Sonicwall TZ170 need to forward port 443 to 2 different servers

Posted on 2009-05-11
3
447 Views
Last Modified: 2012-08-13
I have a SBS2008 domain and I had a backup server that was in a different location. I have brought my backup server to my location and I only have 1 static IP. I need to forward port 443 to both my sbs server and my backup server (ahsay). I had a linksys router but know I can't get this done with that. I have a sonicwall tz170 that I want to put in place.
I think I can get this done with this router but don't know how. How can I get both servers to accept port 443?
0
Comment
Question by:calitech
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
3 Comments
 
LVL 18

Accepted Solution

by:
Don S. earned 500 total points
ID: 24359334
You will need a second external IP address to forward requests on the same port to a second internal destination regardless of the firewall/router you use.  An alternative is to use a different external prot and map that port to 443 of the second internal address.
0
 

Author Comment

by:calitech
ID: 24359413
How to do I handle 2 static IPs? I use one for my router and the other one I don't want to asign to my other server.
0
 
LVL 18

Expert Comment

by:Don S.
ID: 24359711
You simply add a second address to the WAN interface of the Sonicwall.
0

Featured Post

Portable, direct connect server access

The ATEN CV211 connects a laptop directly to any server allowing you instant access to perform data maintenance and local operations, for quick troubleshooting, updating, service and repair.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

In the hope of saving someone else's sanity... About a year ago we bought a Cisco 1921 router with two ADSL/VDSL EHWIC cards to load balance local network traffic over the two broadband lines we have, but we couldn't get the routing to work consi…
There are two basic ways to configure a static route for Cisco IOS devices. I've written this article to highlight a case study comparing the configuration of a static route using the next-hop IP and the configuration of a static route using an outg…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

729 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question