Solved

telnet from secondary Address into Cisco Router

Posted on 2009-05-11
3
1,942 Views
Last Modified: 2012-05-06
I have a secondary address to ping from Cisco Router 870 another Cisco Router by telnet

and if I make a ping is responding
ping 10.127.1.252 source vlan1    ( ok  )

but telnet is not working
telnet  10.127.1.252     ( not working )




interface Vlan1

  ip address 10.127.1.250 255.255.255.0 secondary

!

Open in new window

0
Comment
Question by:victorfranco
  • 2
3 Comments
 
LVL 43

Expert Comment

by:JFrederick29
ID: 24364300
Does the router you are trying to telnet to have restrictions on what source can telnet to it?  If so, you'll need to allow the primary IP address on VLAN1 to telnet to the router.   Or, you can always switch the primary and secondary IP's on the VLAN1 interface.
0
 
LVL 43

Accepted Solution

by:
JFrederick29 earned 500 total points
ID: 24364323
Posted too fast...the router you are trying to telnet to also needs a return route to the primary IP on VLAN1 via 10.127.1.250.  It might simply be easier to swap the primary and secondary, i.e. make 10.127.1.250 the primary IP and the other IP on VLAN1 the secondary.
0
 

Author Closing Comment

by:victorfranco
ID: 31580256
I have exchange the Ip address and both Ip's are working.

Is the solution complete.
Thanks
0

Featured Post

IT, Stop Being Called Into Every Meeting

Highfive is so simple that setting up every meeting room takes just minutes and every employee will be able to start or join a call from any room with ease. Never be called into a meeting just to get it started again. This is how video conferencing should work!

Join & Write a Comment

Suggested Solutions

This is about downgrading PIX Version 8.0(4) & ASDM 6.1(5) to PIX 7.2(4) and ASDM 5.2(4) but with only 64MB RAM and 16MB flash. Background: You have a Cisco Pix 515E which was running on PIX 7.2(4) and its supporting ASDM 5.2(4) without any i…
Quality of Service (QoS) options are nearly endless when it comes to networks today. This article is merely one example of how it can be handled in a hub-n-spoke design using a 3-tier configuration.
It is a freely distributed piece of software for such tasks as photo retouching, image composition and image authoring. It works on many operating systems, in many languages.
Get a first impression of how PRTG looks and learn how it works.   This video is a short introduction to PRTG, as an initial overview or as a quick start for new PRTG users.

708 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

13 Experts available now in Live!

Get 1:1 Help Now