Symantec Security Center Discovery Issue

Today I went to add 5 new machines through the management interface  (SYmantec Center System Console).  It showed the progress of the remote install of the client install on all 5 machines, but in my window where it shows all my machines, 3 of the 5 aren't showing up.

On the two machines that showed up, Symantec Client Security shows up in All Programs.  On the three machines that didn't show up it doesn't.   I've rebooted one of the trouble machines to see if that was needed but that didn't help.  any suggestions?

Who is Participating?
marine7275Connect With a Mentor Commented:
It may be a firewall issue on the 3 machines. Try turning it off or adding the correct exceptions. I also have had to complete the installs locally in the past because of push issues through the console.
dlabbadia01Author Commented:
It was not the firewall, as that was turned off.  But completing the installation locally made the client show up in the management console.  Much thanks
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.