Solved

Cisco ACE Load balancer

Posted on 2009-05-14
2
1,405 Views
Last Modified: 2012-05-07
Hello,

    Has anyone been using the Cisco ACE Load Balancer - Application Control Engine?

I would like to know if it's possible to implement a solution where One ServerFarm communicates with the other ServerFarm - would it need a proxy IP or are there other similar features.

If so, how would we implement that?

Would it be mandatory to use a form of Proxy IP (as compared with a similar solution with the Nortel Alteon Load Balancers)?

0
Comment
Question by:SupraCumLaudae
2 Comments
 
LVL 32

Accepted Solution

by:
harbor235 earned 500 total points
ID: 24387576


I do not believe there is a problem as long as they are on seperate interfaces. If you are using one arm mode or two arm mode that needs to forward traffic back out the same interface, then you may have a problem.

Have you seen this doc?

http://www.cisco.com/application/pdf/paws/107398/client-server-same-vip.pdf

harbor235 ;}
0
 

Author Closing Comment

by:SupraCumLaudae
ID: 31581393
Thanks you for information
0

Featured Post

PRTG Network Monitor: Intuitive Network Monitoring

Network Monitoring is essential to ensure that computer systems and network devices are running. Use PRTG to monitor LANs, servers, websites, applications and devices, bandwidth, virtual environments, remote systems, IoT, and many more. PRTG is easy to set up & use.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
IPv6 question 1 17
Interface VLAN dependencies 6 50
Which Switch is Switch - improving performance 9 63
MAC address learning of Riverbed 4 42
Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
The Cisco RV042 router is a popular small network interfacing device that is often used as an internet gateway. Network administrators need to get at the management interface to make settings, change passwords, etc. This access is generally done usi…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

777 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question