Solved

Internet T3 upgrade

Posted on 2009-05-15
2
389 Views
Last Modified: 2013-12-14
We have a Cisco 3845 that terminates a T3 circuit from the internet provider. Currently we are contracted for 15Mbps and we are upgrading the speed to 45Mbps.
This is the current configuration of the serial interface:
interface Serial1/0
 description DS3-To-Internet
 ip address x.x.x.x 255.255.255.252
 no ip redirects
 no ip unreachables
 no ip proxy-arp
 encapsulation ppp
 no peer neighbor-route
 dsu bandwidth 15300
 scramble
end

So do I just need to change the "dsu bandwidth" to 45000 to upgrade the speed. The provider has already notified that they have updated their side.


0
Comment
Question by:mr_hil22
2 Comments
 
LVL 10

Accepted Solution

by:
stsonline earned 250 total points
ID: 24399721
Yes - change the bandwidth settings and you should be good to go from the router's point of view.
0
 
LVL 34

Assisted Solution

by:Istvan Kalmar
Istvan Kalmar earned 250 total points
ID: 24892962
0

Featured Post

Live: Real-Time Solutions, Start Here

Receive instant 1:1 support from technology experts, using our real-time conversation and whiteboard interface. Your first 5 minutes are always free.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

This article is a guide to configure bridging on Cisco Routers.  This is something I never knew was possible until after making a few phone calls to Cisco.  Using bridging saved our company money by not requiring us to purchase a new switch.  Bridgi…
Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

786 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question