Solved

Proper DD-WRT Firmware for Linksys WRT-54GS2

Posted on 2009-05-16
4
2,953 Views
Last Modified: 2012-06-27
I recently bought a Linksys WRT-54GS2, and would like to use DD-WRT on the device.  I however, cannot find any directions for this specific router.  Has anyone done this yet, or found directions?
Thanks.
Andrew
0
Comment
Question by:Crazy_Penguins
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 3
4 Comments
 
LVL 3

Accepted Solution

by:
flopez235 earned 500 total points
ID: 24404283
DD-WRT group does not have this firmware for this Linksys WRT-54GS2 model yet.  It is too new.

http://www.dd-wrt.com/phpBB2/viewtopic.php?p=298930&highlight=&sid=3261e4b31642c9d68635e4b69db0be4a#top

I'm sure if you check back on the dd-wrt site (http://www.dd-wrt.com/dd-wrtv3/dd-wrt/hardware.html), they'll start working on it soon.

Good luck

0
 

Author Comment

by:Crazy_Penguins
ID: 24404307
Thank you for you comment, however the page you linked to was by buddy asking the same question.  I thought that perhaps some of the experts here could be of more help.
Thank you for your post, and does anyone else have any other ideas?
Thank you.
0
 

Author Comment

by:Crazy_Penguins
ID: 24790976
Any further thoughts on this - if not I'll just close this out.
0
 

Author Comment

by:Crazy_Penguins
ID: 24797063
Okay, I'm just stuck with the Linksys firmware, so it seems.

Thanks for your comment flopez235.
0

Featured Post

On Demand Webinar: Networking for the Cloud Era

Ready to improve network connectivity? Watch this webinar to learn how SD-WANs and a one-click instant connect tool can boost provisions, deployment, and management of your cloud connection.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

It happens many times that access list (ACL) have to be applied to outgoing router interface in order to limit some traffic.This article is about how to test ACL from the router which is not very intuitive for everyone. Below scenario shows simple s…
Creating an OSPF network that automatically (dynamically) reroutes network traffic over other connections to prevent network downtime.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

705 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question