Solved

Cannot ping host but correct IP / MAC addresses show up in ARP table

Posted on 2009-05-19
2
746 Views
Last Modified: 2012-05-07
I created a new host on a static VLAN 10.10.10.x/24 assigned IP address of 10.10.10.113.  From that host machine (.113) i can ping everything in the subnet.  I cannot ping/RDP/connect to 10.10.10.113 from anything on the network....

I checked the switch itself... port set to access mode... no port security.  When I ARP the switch i get the IP address 10.10.10.113 and the corresponding MAC address.

When i try to ping from another host in the same subnet i get timeouts, but when i run arp -a from command prompt it also comes up with the 10.10.10.113 IP and the correct MAC.  
0
Comment
Question by:mattmcp13
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 25

Expert Comment

by:Cyclops3590
ID: 24426855
are you running a firewall on the host itself?  since you say RDP, makes me think you have a Windows host with no exceptions configured on the firewall.
0
 
LVL 2

Accepted Solution

by:
mattmcp13 earned 0 total points
ID: 24426961
i figured it out.  i was configuring a SNORT box on the network and was attempting to telnet to the port without listing 22 for SSH.  so my connections were not going through.  ICMP was turned off on the box itself.  i further confused myself by connecting my Vista laptop and trying to troubleshoot with that....

Once I specified port 22 for SSH everything worked as expected.  
0

Featured Post

Major Incident Management Communications

Major incidents and IT service outages cost companies millions. Often the solution to minimizing damage is automated communication. Find out more in our Major Incident Management Communications infographic.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Creating an OSPF network that automatically (dynamically) reroutes network traffic over other connections to prevent network downtime.
Use of TCL script on Cisco devices:  - create file and merge it with running configuration to apply configuration changes
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Here's a very brief overview of the methods PRTG Network Monitor (https://www.paessler.com/prtg) offers for monitoring bandwidth, to help you decide which methods you´d like to investigate in more detail.  The methods are covered in more detail in o…

734 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question