Solved

how do i obtain cisco 857W router firmware 3.0.10

Posted on 2009-05-19
2
738 Views
Last Modified: 2012-05-07
I have created a cisco username and password.
I have looked on the Cisco site for an indication of the firmware required. (version 3.0.10) I cant seem to get to a link that allows me to download the software.

I am very new to Cisco Systems Routers.
I have a Cisco 857 W and from what i have been able to ascertain, the current firmware is incorrect, as it will not allow 'no ip dhcp use vrf connected' to pass the command line interpreter. the command falls over at 'vrf' as there is no such subcommand in the commands available in the routers firmware.

I was told that 3.0.10 solves this problem, but i need to be able to download a binary image from somewhere.

Any help would be much appreciated.

Thank you.

Brendan Vowles
0
Comment
Question by:Bren
2 Comments
 
LVL 8

Accepted Solution

by:
ludo_friend earned 125 total points
ID: 24429006
it would be the ios that would be incorrect. and 3.0.10 isn't a cisco ios number... 12.3(10) would be what they meant...
12.4(15)T9 is current - which is what I would go for

you can't download ios upgrades unless you have bought support for your router (but its relatively cheap anyway).
http://www.ciscohardwaremaintenance.com/catalog/ciscosmartnetquote.php?smartnetfor=CISCO857W-G-A-K9&smb=1&smbsa=1&engineer=0&cover=8&response=0&length=1
this also gives you a hardware failure warranty and access to TAC.

once you have bought the contract and added it to your account you will have access to cisco downloads.

hope I've helped..
0
 

Author Closing Comment

by:Bren
ID: 31583370
Thank you for your help.
done and dusted.
Cheers,
Brendan Vowles
0

Featured Post

Portable, direct connect server access

The ATEN CV211 connects a laptop directly to any server allowing you instant access to perform data maintenance and local operations, for quick troubleshooting, updating, service and repair.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
Is this QoS Correct on this  CISCO 3825 Router 1 95
DHCP Server 14 100
inserting an ACL line Cisco IOS XR Software, Version 5.3.3 2 51
Home internet speed 20 30
While it is possible to put two routes in place with the secondary having a higher metric, this may not always work. In the event of a failure that does not bring down the physical interface on the router the primary route is not removed. There is a…
It happens many times that access list (ACL) have to be applied to outgoing router interface in order to limit some traffic.This article is about how to test ACL from the router which is not very intuitive for everyone. Below scenario shows simple s…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

860 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question