• Status: Solved
  • Priority: Medium
  • Security: Public
  • Views: 1560
  • Last Modified:

configuring Cisco 1130AG for WPA-PSK

Hi,

Cisco seem to make their devices extremely difficult to setup for WPA-PSK encryption, can anyone shed light on how to configure this through the GUI?  

The express setup page can't do it without using a radius server, if you set the encryption manually to TKIP or AES CCMP and then enable WPA through the SSID manager, the clients are unable to connect.
0
partymarty84
Asked:
partymarty84
1 Solution
 
nasirshCommented:
To configure the WPA-PSK, perform these steps using the GUI interface:

   1. In the Encryption Manager window, select cipher TKIP and click Apply.
   2. In the Service Set Identifier (SSID) Manager window, perform these steps:
         1. Create an SSID.
         2. Select Open Authentication.
         3. Set the Key Management to Mandatory.
         4. Check the WPA box.
         5. Enter a WPA-PSK and click Apply.
0
 
partymarty84Author Commented:
Thanks nasirsh, I figured it out eventually by myself. I think the steps you've listed are correct so i'll mark it as the solution.
0

Featured Post

SMB Security Just Got a Layer Stronger

WatchGuard acquires Percipient Networks to extend protection to the DNS layer, further increasing the value of Total Security Suite.  Learn more about what this means for you and how you can improve your security with WatchGuard today!

Tackle projects and never again get stuck behind a technical roadblock.
Join Now