Cisco router skipping enable prompt

I have a 1840 router all configured up the same as my other Cisco gear (as far as device access goes), but this one router is acting funky. When I SSH to the device, I enter my username and password, once that has been confirmed it skips right into privileged mode without prompting for an enable password, even though the enable secret has been set. Here is the relevant portion of the code, and the screen text of the occurance.

Current configuration : 9346 bytes
! Last configuration change at 08:08:12 DST Thu May 21 2009 by administrator
! NVRAM config last updated at 21:27:21 DST Sun May 10 2009 by administrator
version 12.4
no service pad
service tcp-keepalives-in
service tcp-keepalives-out
service timestamps debug datetime msec localtime show-timezone
service timestamps log datetime msec localtime show-timezone
service password-encryption
service sequence-numbers
hostname INNOV_KS
security authentication failure rate 3 log
security passwords min-length 6
logging buffered 4096
enable secret 5 $1$okD8$ir5T5irWSTXgzeWNG4Iwd0
aaa new-model
aaa authentication login userauthen local
aaa authorization network groupauthor local
username administrator secret 5 $1$OVHR$y7WQM99g375OdWBaoUEQS0
username mtsadmin secret 5 $1$1BYS$yR84s42Z9M6q3cWLmN96k.
banner login ^CCCAuthorized access only!
 Disconnect IMMEDIATELY if you are not an authorized user!^C
line con 0
 login authentication userauthen
line aux 0
 access-class 2 in
 login authentication userauthen
 modem InOut
 transport output telnet
 stopbits 1
 speed 115200
 flowcontrol hardware
line vty 0 4
 access-class 10 in
 exec-timeout 30 0
 privilege level 15
 login authentication userauthen
 transport input ssh
line vty 5 15
 access-class 10 in
 login authentication userauthen
 transport input ssh

login as: administrator
CCAuthorized access only!
 Disconnect IMMEDIATELY if you are not an authorized user!Using keyboard-interactive authentication.


As you can see above it goes straight to privigeled mode, which does not happen on other devices with the same device access config. Any suggestions on how to fix this?
Who is Participating?
Don JohnstonConnect With a Mentor InstructorCommented:
Remove the "privilege level 15" from the vty line config.
cziggyAuthor Commented:
Well, easier than I thought it was, didn't really notice that line in there. Thanks for the prompt solution.
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.