I am trying to setup Exchange in SCC cluster mode. During the Exchange install I discovered that I actually need to setup a Windows Cluster first in order to get the Exchange into a cluster mode. When I try and setup a Windows cluster, it all seems to be going fine, until it's actually "Forming" the cluster, then it fails. I tried searching online, and the only thing I really found was that it might be because I don't have IPv6 running?
Here is the creation log, if anyone has any ideas.
IP Address: 10.1.1.10
Started 5/25/2009 9:17:47 PM
Completed 5/25/2009 9:20:55 PM
Beginning to configure the cluster SAT-EXCHCL-0001.
Initializing Cluster SAT-EXCHCL-0001.
Validating cluster state on node SAT-EXCH-0001.SATORITECH.den.
Searching the domain for computer object 'SAT-EXCHCL-0001'.
Creating a new computer object for 'SAT-EXCHCL-0001' in the domain.
Configuring computer object 'SAT-EXCHCL-0001' as cluster name object.
Validating installation of the Network FT Driver on node SAT-EXCH-0001.SATORITECH.den.
Validating installation of the Cluster Disk Driver on node SAT-EXCH-0001.SATORITECH.den.
Configuring Cluster Service on node SAT-EXCH-0001.SATORITECH.den.
Validating installation of the Network FT Driver on node SAT-EXCH-0002.SATORITECH.den.
Validating installation of the Cluster Disk Driver on node SAT-EXCH-0002.SATORITECH.den.
Configuring Cluster Service on node SAT-EXCH-0002.SATORITECH.den.
Waiting for notification that Cluster service on node SAT-EXCH-0001.SATORITECH.den has started.
Forming cluster 'SAT-EXCHCL-0001'.
Unable to successfully cleanup.
To troubleshoot cluster creation problems, run the Validate a Configuration wizard on the servers you want to cluster.
An error occurred while creating the cluster. An error occurred creating cluster 'SAT-EXCHCL-0001'. This operation returned because the timeout period expired.