Solved

cisco asa upgrade

Posted on 2009-06-30
4
2,920 Views
Last Modified: 2012-05-07
i have just upgraded asa to version 7.2 and asdm 5.2 but when i oprn asdm is says 5.2 does not support asa 7.1

looking at my config in cli it must be booting to 7.1

ASA Version 7.1(2)

boot system disk0:/asa712-k8.bin
boot system disk0:/asa722-k8.bin

how do i get the firewall to boot using the new image, i have already set using the:
boot system disk0:/asa722-k8.bin

and if i do again to make sure it says
Unable to set this url, it has already been set
Remove the first instance before adding this one

please advise, i assume i need to remove the asa712-k8.bin but there is nothing in the instructions for upgrading
0
Comment
Question by:hercnemesis
  • 2
  • 2
4 Comments
 
LVL 1

Author Comment

by:hercnemesis
ID: 24746216
0
 
LVL 16

Accepted Solution

by:
2PiFL earned 125 total points
ID: 24746483
in config mode:
ASA# conf t
ASA(config)# no boot system disk0:/asa712-k8.bin
ASA(config)# exit
ASA#wr mem
0
 
LVL 16

Expert Comment

by:2PiFL
ID: 24746504

You'll need to restart the ASA to load the new image.
0
 
LVL 1

Author Closing Comment

by:hercnemesis
ID: 31598377
excellent, thankyou very much, all sorted, now running 7.2 and 5.2 asdm, hopefully now can setup L2tp
0

Featured Post

IT, Stop Being Called Into Every Meeting

Highfive is so simple that setting up every meeting room takes just minutes and every employee will be able to start or join a call from any room with ease. Never be called into a meeting just to get it started again. This is how video conferencing should work!

Join & Write a Comment

This is about downgrading PIX Version 8.0(4) & ASDM 6.1(5) to PIX 7.2(4) and ASDM 5.2(4) but with only 64MB RAM and 16MB flash. Background: You have a Cisco Pix 515E which was running on PIX 7.2(4) and its supporting ASDM 5.2(4) without any i…
From Cisco ASA version 8.3, the Network Address Translation (NAT) configuration has been completely redesigned and it may be helpful to have the syntax configuration for both at a glance. You may as well want to read official Cisco published AS…
Here's a very brief overview of the methods PRTG Network Monitor (https://www.paessler.com/prtg) offers for monitoring bandwidth, to help you decide which methods you´d like to investigate in more detail.  The methods are covered in more detail in o…
This video shows how to remove a single email address from the Outlook 2010 Auto Suggestion memory. NOTE: For Outlook 2016 and 2013 perform the exact same steps. Open a new email: Click the New email button in Outlook. Start typing the address: …

743 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

13 Experts available now in Live!

Get 1:1 Help Now