Solved

Sun 420R running Solaris 10 two NIC Cards - Need to setup Network

Posted on 2009-07-01
6
571 Views
Last Modified: 2013-12-23
I have a Sun420 running Solaris 10 with two NIC cards. I would like to bring up both networks through a PuTTY window from my laptop or other desktop. I just installed Solaris 10 and is running well but think the networks are mis-configured. I have no idea how to determine what the P address for the server or two networks should but would like to initially get running and later connect to my WIFI router for Internet access. Can someone guide me through the steps to create a valid IP address for the server and networks along with configuration through the GUI tool smc if this is the chosen tool?
0
Comment
Question by:rayskelton
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 3
  • 2
6 Comments
 
LVL 57

Expert Comment

by:giltjr
ID: 24777011
There is no specific way to determine what the IP address should be for a host.  You pick one in the IP subnet and assign it.  I can be any IP address within your subnet as long as it is not part of a DHCP scope or is not already assigned to another host.
0
 
LVL 40

Expert Comment

by:omarfarid
ID: 24777887
you may configure your system to use DHCP to get IP addresses assigned.
0
 

Accepted Solution

by:
rayskelton earned 0 total points
ID: 24947850
No acceptable solution provided.
0
SharePoint Admin?

Enable Your Employees To Focus On The Core With Intuitive Onscreen Guidance That is With You At The Moment of Need.

 

Author Comment

by:rayskelton
ID: 24947856
.
0
 

Author Comment

by:rayskelton
ID: 24947860
no acceptable solution provided.
0
 
LVL 40

Expert Comment

by:omarfarid
ID: 24948785
does this mean that you got your problem solved? if yes, can you share with us how?
0

Featured Post

On Demand Webinar: Networking for the Cloud Era

Did you know SD-WANs can improve network connectivity? Check out this webinar to learn how an SD-WAN simplified, one-click tool can help you migrate and manage data in the cloud.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

#Citrix #Citrix Netscaler #HTTP Compression #Load Balance
Arrow Electronics was searching for a KVM  (Keyboard/Video/Mouse) switch that could display on one single monitor the current status of all units being tested on the rack.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Michael from AdRem Software explains how to view the most utilized and worst performing nodes in your network, by accessing the Top Charts view in NetCrunch network monitor (https://www.adremsoft.com/). Top Charts is a view in which you can set seve…
Suggested Courses

632 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question