epifanio67
asked on
centos 5.3 kernel parameters missing, how to change/set?
Hello Experts,
I just tried to install Oracle 11g (2 attempt). The install failed because these parameters were missing or not set (I am not sure)
semopm=100; semopm=32
ip_local_port_range=1024 - 65000; ip_local_port_rage=32768 - 6100
rnem_default=4194304; rnem_default=126976
rnem_max=4194304; rnem_max=131071
wnem_default=262144; wnem_default=126976
wnem_max=262144; wnem_max=131071
how do I change/set these parameters?
thx,
regards,
I just tried to install Oracle 11g (2 attempt). The install failed because these parameters were missing or not set (I am not sure)
semopm=100; semopm=32
ip_local_port_range=1024 - 65000; ip_local_port_rage=32768 - 6100
rnem_default=4194304; rnem_default=126976
rnem_max=4194304; rnem_max=131071
wnem_default=262144; wnem_default=126976
wnem_max=262144; wnem_max=131071
how do I change/set these parameters?
thx,
regards,
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
got it... thx so much unSpawn....
Regards,
Regards,
You're welcome!
ASKER
well, I installed the rpm packages missing. I tried to run the oracle installer again;all rpm packages check pass.. but now I am only missing one param
rnem_default = 4194304; rnem_default = 126976
could you tell me again how to change/set these?
this is all I need to complete my install... thx so much
thx,