Solved

PIX 501 Multiple public ip's inside

Posted on 2009-07-03
2
435 Views
Last Modified: 2012-05-07
I have a Cisco PIX 501 curently with a range of ip's configured on the outside interface. These are then NAT'ed through to a coresponding server on the inside were the servers on the inside have private network addresses.
Is there a way that I can configure the PIX to route the public ip's into the inside so that I can configure the servers with there public IP's and have the pix filter the ports that are allowed to pass through? If so how or can you point me in the direction of some documentation.

Cheers Bruce
0
Comment
Question by:Brucemat
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 34

Expert Comment

by:Istvan Kalmar
ID: 24774633
0
 
LVL 79

Accepted Solution

by:
lrmoore earned 500 total points
ID: 24774725
Short answer - no.
Not with the 501.
With a 515 or higher running 7.x or higher, or with ASA 5500, you can run the firewall in L2 transparent mode. There are tradeoffs like no support for VPN in transparent mode, but you can use the public IP's directly on the end device as you wish.
However, you cannot do both at the same time with some hosts using dynamic nat for outbound and some hosts using transparent mode with their own public ip's.
0

Featured Post

Independent Software Vendors: We Want Your Opinion

We value your feedback.

Take our survey and automatically be enter to win anyone of the following:
Yeti Cooler, Amazon eGift Card, and Movie eGift Card!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
Single Number Reach 3 50
Cisco RV320 Gateway to Gateway connected but not passing traffic 6 27
Rogue RDP Connections 5 58
Copying out Cisco backups from SolarWinds 13 61
In the world of WAN, QoS is a pretty important topic for most, if not all, networks. Some WAN technologies have QoS mechanisms built in, but others, such as some L2 WAN's, don't have QoS control in the provider cloud.
For months I had no idea how to 'discover' the IP address of the other end of a link (without asking someone who knows), and it drove me batty. Think about it. You can't use Cisco Discovery Protocol (CDP) because it's not implemented on the ASAs.…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
As a trusted technology advisor to your customers you are likely getting the daily question of, ‘should I put this in the cloud?’ As customer demands for cloud services increases, companies will see a shift from traditional buying patterns to new…

756 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question