greekstones
asked on
WAN and VOICE on the same E1 Circuit
hi there
is it possible to split one E1 circuit for data and voice. Basicly we have one HDSL E1 circuit and we would like to use it for WAN but the also to use it to route PSTN calls.
does anybody done that before.
is it possible to split one E1 circuit for data and voice. Basicly we have one HDSL E1 circuit and we would like to use it for WAN but the also to use it to route PSTN calls.
does anybody done that before.
Why not just get a voip provider ?, and do voice over IP ? You would ultimately get more voice channels for less money using existing equipment.
ASKER
hi xuserx2000:
any sample configuration please for Fractional E1 .
the reason that we are going that way is because the voip in the country that we trying to install is very expencive . is cheaper to buy E1 than Voip , is know is crazy.
any sample configuration please for Fractional E1 .
the reason that we are going that way is because the voip in the country that we trying to install is very expencive . is cheaper to buy E1 than Voip , is know is crazy.
ASKER
sorry if you can send me some sample configuration on T1 that will be great
What kind of hardware are you using to connect ?
ASKER
2811
ASKER
Hi there
Sorry yes my divice is Cisco 2811.
regards.
Sorry yes my divice is Cisco 2811.
regards.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
It's a split circuit into analog voice and data.
I've done fractional T1's, but i'm in the US and we don't have E1.