dbhatoa
asked on
Cisco 2600 - Configuration settings will not save
Hi,
I've followed the password reset procedure at:-
http://www.cisco.com/en/US/products/hw/routers/ps259/products_password_recovery09186a0080094675.shtml
I have a problem when I go to reboot the device after an initial setup the configuration settings aren't saved to startup and I'm left with a blank configuration.
Any help would be much appreciated.
Not sure if its related, but hyper terminal is unresponsive when being used with the router, I've resorted to using Tera Term.
tx
I've followed the password reset procedure at:-
http://www.cisco.com/en/US/products/hw/routers/ps259/products_password_recovery09186a0080094675.shtml
I have a problem when I go to reboot the device after an initial setup the configuration settings aren't saved to startup and I'm left with a blank configuration.
Any help would be much appreciated.
Not sure if its related, but hyper terminal is unresponsive when being used with the router, I've resorted to using Tera Term.
tx
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.