Solved

VPN Latency Issues

Posted on 2009-07-08
3
810 Views
Last Modified: 2012-05-07
I currently have a site to site VPN using two ISP's (Geographic separations) and I am seeing very large latency across when I run pings across it (300-500ms)  I understand the internet is best effort, but this is unusually high....on the network pings are returned 12-15ms...its just when they are initiated across the VPN that I see the high returns....I am running 3DES, and was wondering if going to 128 AES would alleviate the strain, or if I should check with the ISP's as well?
0
Comment
Question by:bbresslin
  • 2
3 Comments
 
LVL 9

Accepted Solution

by:
jfer0x01 earned 500 total points
ID: 24807044
Hi,

isp if going to go off of ping speed, not vpn performance

try pinging with a full packet size, to see if you get the same amount of latency

try ping -s 65355 to the other site and vice versa

implementing another encrption protocol may help if ping return sizes are acceptable

Jfer
0
 
LVL 9

Expert Comment

by:jfer0x01
ID: 24891139
any progress?
0
 
LVL 1

Author Closing Comment

by:bbresslin
ID: 31601179
Issue was on the ISP side....connection is pegged...
0

Featured Post

Netscaler Common Configuration How To guides

If you use NetScaler you will want to see these guides. The NetScaler How To Guides show administrators how to get NetScaler up and configured by providing instructions for common scenarios and some not so common ones.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Sometimes, you want your microsoft VPN to route all the traffic to the remote network. Usually your employer network. This makes it possible to access all the nodes inside this remote LAN, even if they have no "public DNS" entries. To do so, you wo…
This is an article about my experiences with remote access to my clients (so that I may serve them) and eventually to my home office system via Radmin Remote Control. I have been using remote access for over 10 years and have been improving my metho…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Windows 10 is mostly good. However the one thing that annoys me is how many clicks you have to do to dial a VPN connection. You have to go to settings from the start menu, (2 clicks), Network and Internet (1 click), Click VPN (another click) then fi…

772 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question