Solved

Vigor 3300v firewall and VLAN's

Posted on 2009-07-08
3
1,466 Views
Last Modified: 2013-11-16
How do I setup 2 VLANS with a Vigor 3300v firewall.  I have two seperate neworks on the same subnet adress and I want to set up a route between the two. I can't seem to find where I assign an IP Address to the Vlan interfaces on the 3300v, does anybody know?
0
Comment
Question by:mistyfly
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
3 Comments
 
LVL 14

Expert Comment

by:grimkin
ID: 24805180
Hi,

I don't have a 3300v but it should be the same as the older models - you basically assign a port to a VLAN by ticking a box.

Go to  Advanced Setup > VLAN/Rate Control  (or similar, mine is a 2600v)

Click Enable then check the boxes to assign ports to a VLAN.

The Draytek support site has a more visual representation than I can describe here: http://www.draytek.co.uk/support/kb_vigor_vlan.html

Let me know if this doesn't answer your question ..

HTH
0
 

Author Comment

by:mistyfly
ID: 24805286
I have the area which allows me to tick the boxes (like in the link you sent). Can I put a route between the two vlans I want one of the networks to access an IP on the other network too. How do I assign an IP to the vlan port on the draytek? Or do I just assign the gateway address as the vigors ip address on both vlans?
0
 
LVL 14

Accepted Solution

by:
grimkin earned 500 total points
ID: 24805507
Hi,

I've looked at the user guide and the 3300 seems to be a bit more advanced than my old 2600. Check out A.3.1 on page 145 in the user guide this is the scenario which I think will apply to you.

The router should route between these LANs automatically unless it is configured NOT to pass LAN-to-LAN communication as depicted on page 137.

HTH, let me know how you get on.
UG-Vigor3300series-V2.1.pdf
0

Featured Post

Independent Software Vendors: We Want Your Opinion

We value your feedback.

Take our survey and automatically be enter to win anyone of the following:
Yeti Cooler, Amazon eGift Card, and Movie eGift Card!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

In the hope of saving someone else's sanity... About a year ago we bought a Cisco 1921 router with two ADSL/VDSL EHWIC cards to load balance local network traffic over the two broadband lines we have, but we couldn't get the routing to work consi…
How to set-up an On Demand, IPSec, Site to SIte, VPN from a Draytek Vigor Router to a Cyberoam UTM Appliance. A concise guide to the settings required on both devices
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Email security requires an ever evolving service that stays up to date with counter-evolving threats. The Email Laundry perform Research and Development to ensure their email security service evolves faster than cyber criminals. We apply our Threat…

734 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question