Cisco Pix 501 PDM issue

I just reconfigured my IP scheme for my internal network. I have rebooted everything and all is ok with the exception of one thing, my Cisco PIX 501 PDM access. I changed the inside interface address and can telnet to the device. I have went in and created a name for my workstation and gave it the correct ip address and set the pdm to that ip. I have also allowed pdm access to my entire interal ip range. Still, everytime I go to access the pdm I get a "This page can not be displayed". I have tried both http and https. Any suggestions?
LVL 14
Who is Participating?
MCSA2003Connect With a Mentor Author Commented:
I appreciate the help but I fixed the issue. I was posting the config as you requested and when I went through it with a fine tooth comb I realized I made a mistake. I had the following:

http inside

It should have been:

 http inside

Once I made the change it worked.
Can you post the config?
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.