naiadmin
asked on
Dynamic voice and data Nxt1 with Cisco UC520 configuration
I going to be moving into a locaiton that has a dynamicvoice and data NxT1(PRI) the carrier is installing. The carrier is providing the cisco 1800 series router. I will most likley be getting a FE handoff from the carrier...How do I go about setting up the UC520 to handle this? The carrier will be doing the multililnk. I've done this with single T1's and a CSU, but if I'm not setting up the multilink, how would I go about setting up the UC520 to deal with this type of connection?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ip route 0.0.0.0 0.0.0.0 10.1.1.10