amigan_99
asked on
How to determine if DSPs installed in 2811?
I am fairly certain that I have PVDM2-48 48 channel packet voice/fax DSP module installed in my 2811 router. "show hardware" does not indicate its presence. But in another router I am clearly using DSP resources for conference calling. What Cisco IOS "show" command indicates the presence of this DSP module? Thanks.
Sample output of show hardware:
Cisco 2811 (revision 53.51) with 245760K/16384K bytes of memory.
Processor board ID FTX101010101011
2 FastEthernet interfaces
1 Gigabit Ethernet interface
1 Serial interface
2 terminal lines
2 Channelized T1/PRI ports
1 cisco service engine(s)
DRAM configuration is 64 bits wide with parity enabled.
239K bytes of non-volatile configuration memory.
126976K bytes of ATA CompactFlash (Read/Write)
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER