Solved

UC520 CLI configuration

Posted on 2009-07-14
4
1,043 Views
Last Modified: 2013-11-16
How do I add DID's into a UC520 using the CLI?
0
Comment
Question by:Bosaloski
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
  • 2
4 Comments
 
LVL 16

Expert Comment

by:memo_tnt
ID: 24853888
you need to add the following rule:
voice translation-rule 1
rule 1 /xxxxx.../ /y.../ >>> xxx is your DID and y your extension
!
voice translation-profile DID
translate called 1
dial-peer voice 4 pots
incoming called-number .
port 0/1:23 >> assuming the voice interface on the PRI
direct-inward-dial
translation-profile incoming DID
!
!
Try and reply
0
 
LVL 16

Expert Comment

by:memo_tnt
ID: 24861596
is it solved with you ??
0
 

Author Comment

by:Bosaloski
ID: 24863731
I have not had a chance to work on this yet.  Knology has not gotten back to me with teh DID numbers.  I will comment tomorrow when I can enter the DID's
0
 

Accepted Solution

by:
Bosaloski earned 0 total points
ID: 24919957
I have tried this solution and I am still getting a buzy signal.  I set up 2 of these DID's on an Cisco 2600 to test and they work fine.  ON the UC520 I have set them up in the configuration assisstant and reviewed the CLI.  The "translate" and "ephone" command lines were there, but not working.  Is there something else required that I have missed?
0

Featured Post

IoT Devices - Fast, Cheap or Secure…Pick Two

The IoT market is growing at a rapid pace and manufacturers are under pressure to quickly provide new products. Can you be sure that your devices do what they're supposed to do, while still being secure?

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Data center, now-a-days, is referred as the home of all the advanced technologies. In-fact, most of the businesses are now establishing their entire organizational structure around the IT capabilities.
Use of TCL script on Cisco devices:  - create file and merge it with running configuration to apply configuration changes
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Michael from AdRem Software outlines event notifications and Automatic Corrective Actions in network monitoring. Automatic Corrective Actions are scripts, which can automatically run upon discovery of a certain undesirable condition in your network.…
Suggested Courses

630 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question