Solved

DHCP Problem with 3Com SuperStack with Fiber - No UDP 67 broadcast on fiber

Posted on 2009-07-15
1
418 Views
Last Modified: 2012-05-07
Good day.

I have 2x 3COM superstack with fiber link connected between the stacks and I had to reset them to factory default.  Both models for fiber are 4228G and now the traffic cannot pass from one to another.  I understood there was 3 VLANs configured before from another tech but obviously, the links kept on going up and down randomly, therefore explaining why I have decided to reset to factory default.

What I really want to do is have the Switch act as 2x L2 Dumb switch with the least amount of software from 3COM.  My logic was to do a reset to factory default on both....However, now there is no communication going on between the stacks.  There is no ports that are tagged and I want everything to run on VLAN 1(default) because the DHCP is on the same subnet.  What must I do to have those 2 fiber link appear as on the same subnet.

Thank you in advance.
0
Comment
1 Comment
 
LVL 5

Accepted Solution

by:
JanSc earned 500 total points
ID: 24868858
Sounds odd, but shutdown the fibre interfaces. Wait a few seconds and then enable the interfaces.
Most times it works after factory reset.
0

Featured Post

What Security Threats Are You Missing?

Enhance your security with threat intelligence from the web. Get trending threat insights on hackers, exploits, and suspicious IP addresses delivered to your inbox with our free Cyber Daily.

Join & Write a Comment

Suggested Solutions

The worst thing when starting a new job is when the previous Network Administrator left behind no documentation. How do you get into the devices? If you've been in this situation or just accidently mistyped your password, this article will hopefully…
I eventually solved a perplexing problem setting up telnet for a new switch.  I installed a new Cisco WS-03560X-24P switch connected to an existing Cisco 4506 running a WS-X4013-10GE Sup II-Plus. After configuring vlans and trunking,  I could no…
Sending a Secure fax is easy with eFax Corporate (http://www.enterprise.efax.com). First, Just open a new email message.  In the To field, type your recipient's fax number @efaxsend.com. You can even send a secure international fax — just include t…
When you create an app prototype with Adobe XD, you can insert system screens -- sharing or Control Center, for example -- with just a few clicks. This video shows you how. You can take the full course on Experts Exchange at http://bit.ly/XDcourse.

705 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

20 Experts available now in Live!

Get 1:1 Help Now