ASA failover

Jelonet
Jelonet used Ask the Experts™
on
I have 2 ASA 5520's and I configured active/standby failover. I have reade everything I could find fron Cisco how to pass statefull information across the same link. I can't seem to get this working. The failover link works fine but I am not sure how to configure the state link using this failover link. This is the only interface I have available and would like to use this interface for both the failover and stateful link.
Comment
Watch Question

Do more with

Expert Office
EXPERT OFFICE® is a registered trademark of EXPERTS EXCHANGE®
I am sure you have seen this document, but here it is in case you missed it.
http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00807dac5f.shtml

The key line you are looking for is this line below:
hostname(config)#failover link if_name phy_if


That is about it, the stateful piece is a pretty basic setup.

If you still have problems and wish to post your config please do so.

Regards,

3nerds

Do more with

Expert Office
Submit tech questions to Ask the Experts™ at any time to receive solutions, advice, and new ideas from leading industry professionals.

Start 7-Day Free Trial