bigdaddy318
asked on
CISCO AIRONET - How to configure the passwords for HTTP access. Telnet is fine.
Hello,
I am able to log into my Aironet via the Telnet session, and fortunately am still able to get to enable privileged mode. I have somehow screwed up my ability to log in via the web interface. Please steer me in the right direction with the Cisco syntax. I have the following lines in my config:
no service password encryption
ip http server
no ip http secure-server
username bigdaddy privilege 15 password 0 hooah
I would think that I should be able to log into the Web Interface password window with the username 'bigdaddy' and password 'hooah' and see the GUI. It rejects any combination that I use, and says that I need a level 15 password.
HElp please.
thanks, Jeff
I am able to log into my Aironet via the Telnet session, and fortunately am still able to get to enable privileged mode. I have somehow screwed up my ability to log in via the web interface. Please steer me in the right direction with the Cisco syntax. I have the following lines in my config:
no service password encryption
ip http server
no ip http secure-server
username bigdaddy privilege 15 password 0 hooah
I would think that I should be able to log into the Web Interface password window with the username 'bigdaddy' and password 'hooah' and see the GUI. It rejects any combination that I use, and says that I need a level 15 password.
HElp please.
thanks, Jeff
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
that did it. thanks. apparently was doing authentication global before.
plz post your configuration