asked on

PcAnywhere and Linksys Router

Can someone direct me to a link that explains how to set up PcAnywhere and a Linksys Route so that I can access two or three remote computers attched to a single Linksys router.

Maniac_47

Please follow this article, as I believe this is what you are looking for:

http://service1.symantec.com/SUPPORT/pca.nsf/docid/2001062209313012

this basically explains how to change the ports each listen on so you can port forward requests to multiple machines running behind 1 router with 1 public IP address. You'll just need to configure the linksys router to forward requests to the remote machines' private ip addresses based on the ports you set them to run on (found under "Applications and Gaming" section of most linksys routers)

akbiro

ASKER

Sweet...this is unbelievable. I have asked this same question 3 tmies and was always given things to do that never worked. Let me ask you this. I set up each PCA host to a different port 5631 & 32 on one 5633 & 34 on one and 5635 & 36 on the third one. Then I went to the router and set up those same ports for the TCIP connections 192.168.1.120, 119 & 118.

So now when I go to my computer that I will run Remote on to dial in and try to access the three computers over the internet with my IP address...I am automatically connected to just one of the computers, the 119. How can I get it to let me choose which one I want.

ASKER CERTIFIED SOLUTION

Maniac_47

membership

This solution is only available to members.

To access this solution, you must be a member of Experts Exchange.

Start Free Trial

Maniac_47

Is this still causing you an issue / is there anything else I can help you with?

akbiro

ASKER

I feel like an idiot, but under the Details window in my remote tcp/id I have two choices, Dial up Network where I have check Connet to PcAnywhere hose using a local area network and Gateway, nothing about TCP and UDP ports. What am I missing.

akbiro

ASKER

I finally got it...you did great and thank you VERY much. I have to decide when I dial in which computer I want and change the ports for each look up...that now I get it and thanks again.