chikagoh
asked on
Cisco Call Manager Express 1+ Area Code dialing failing to local extensions
I have a CME system with extensions in the 100-200 range. I would like to enable 1+(area code) dialing, but when I set the dial-peer for 1[2-9]......... it stops after 3 digits because of the local extensions.
For examplel if I want to dial 1-312-111-2222, it stops on 131
Any way around this?
For examplel if I want to dial 1-312-111-2222, it stops on 131
Any way around this?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
I will test these and get back.
Thanks!
David
Thanks!
David
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
voice translation-rule 1
rule 1 /^9/ //
voice translation-profile dialout
translate called 1
dial-peer voice 8 pots
translation-profile outgoing dialout
destination-pattern 9T
port 2/0
That sets up dialing 9 for an outside line.
Greg
rule 1 /^9/ //
voice translation-profile dialout
translate called 1
dial-peer voice 8 pots
translation-profile outgoing dialout
destination-pattern 9T
port 2/0
That sets up dialing 9 for an outside line.
Greg
ASKER
There's a few different ways to skin this cat. Thanks much to all.
dial-peer voice 8 pots
destination-pattern .T
port 2/0
This allows the router to match anything not covered by other dial-peers to go out of an fxo port.
Greg