aasikolo
asked on
Netgear Wireless router
I am trying to set up a wireless network, but my router does not have a USB port to use the thumb drive option in the XP wireless network wizard. Instructions say Ithe unrecommended option is to manually enter the wireless network settings for each device, whic hI cannot find out how to do.
Don't know where to begin.
Pleae advise.
Thank you.
aasikolo
Don't know where to begin.
Pleae advise.
Thank you.
aasikolo
Once the wireless network is created and you try to join clients to the network it will ask for the key. you ahve the option of putting it on a usb key or manually typing it in, but it is that simple. Write the key down from the router. Find the network on the client computer, Join the network and then provide the key when asked. As long as router does DHCP and is all setup the clients will start to comunicate.
Please install D link wireless network card on your desktop, give the static IP address & do proper settings of router as per & then try to connect.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
I'm sorry it has taken so long to respond. This instruction should be plastered on the front page of this website.
Thank you very much
aasikolo
Thank you very much
aasikolo
There is a link to a video on the right side of the webpage under related documents that shows how to get started. It usually is not that difficult. There should be a wizard as well. Give it a go and let us know if you run into trouble.