• Status: Solved
  • Priority: Medium
  • Security: Public
  • Views: 637
  • Last Modified:

Compatible easy setup routers to vpn site to site with Cisco asa 5505 that supports NAT

Hello, I am new to EE.

I have tried searching for my answer and found one that was close to my answer but I require a little more info.  Basically the Provider requires us to have a VPN tunnel connected to them. We currently have a Linksys / Cisco WRVS4400N. I can get the vpn to connect but they require a model that will take all traffic coming from my network over the VPN to be NAT'd to my Internet IP instead of an IP in my local address space.  I found out that the WRVS4400N doesn't support that type of Nat. So I was looking into an easy model to configure to replace it, like a RV042 etc... but in my search I found it doesn't either . Is there a model that someone can recommend that is easy to configure and setup to connect to there tunnel. I am not able to use the configure cisco models such as a 5505 as I lack the knowledge so an easy web interface model without having to console would be great. I read a few days ago there is a netgear model that supports that type of nat but have no idea the model. Any Suggestions?
0
mvtvc
Asked:
mvtvc
  • 3
  • 3
1 Solution
 
memo_tntCommented:
Hi

i recommend to use the ASA module ,, it has a very good GUI
check the following links for site 2 site configuration that answer you question

http://www.cisco.com/en/US/products/ps5855/products_configuration_example09186a0080a9a7a3.shtml

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a0080aa5be1.shtml

Also; juniper has products with easly GUI interface , i heard about them that they are good
but i didn't use them before

for me i recommend CISCO ASA models

0
 
mvtvcAuthor Commented:
I thought that is what most would say. I like the noob interface such as what is in the current model I have. Any models you can think of that support the Nat I need? what about the cisco rvl200?  I found this website about it and mentions NAT but not sure if it will support the nat options I need.  http://www.smallnetbuilder.com/content/view/30237/51/
0
 
memo_tntCommented:
from its specifications it supports NAT ,, but am not 100% sure cause i didnt use it before

and for the ASA , it's for sure supporting all NAT rules ..
0
Evaluating UTMs? Here's what you need to know!

Evaluating a UTM appliance and vendor can prove to be an overwhelming exercise.  How can you make sure that you're getting the security that your organization needs without breaking the bank? Check out our UTM Buyer's Guide for more information on what you should be looking for!

 
mvtvcAuthor Commented:
Ok I guess what would be helpful is to know what is the type of Nat I need to look for in possible compatible models? Is what I am looking for called one to one Nat? or is it MultiThread Nat? or ????
0
 
memo_tntCommented:
you need to setup a dynamic NAT 1st
then you need to setup a static NAT depends on your requirements ??
0
 
mvtvcAuthor Commented:
I didn't get a answer of what other possible routers would correctly vpn into a cisco asa-5505.
0

Featured Post

Free Tool: Site Down Detector

Helpful to verify reports of your own downtime, or to double check a downed website you are trying to access.

One of a set of tools we are providing to everyone as a way of saying thank you for being a part of the community.

  • 3
  • 3
Tackle projects and never again get stuck behind a technical roadblock.
Join Now