CISCO 877 command to show outbound connection

DVI3
DVI3 used Ask the Experts™
on
I would like to see all outbound active connection (Ip address, port, and dest ip address) on my Cisco 877.

What command would I need to run ?
Comment
Watch Question

Do more with

Expert Office
EXPERT OFFICE® is a registered trademark of EXPERTS EXCHANGE®
Commented:
use these commands:

! Select the interface:
Router(config-if)# ip route-cache flow

! send data to collector
Router(config)# ip flow-export destination 172.17.246.225 9996
Router(config)# ip flow-export version 9
Router(config)# ip flow-export source loopback 0

! enable CEF even using policy routing
ip route-cache policy

!After that exit to exec level
exit

! see the result
sh ip cac f
The best command is:

sh ip nat translation

Do more with

Expert Office
Submit tech questions to Ask the Experts™ at any time to receive solutions, advice, and new ideas from leading industry professionals.

Start 7-Day Free Trial