Making QoS configuration on Cisco 878 Point-to-Point
Making QoS configuration on Cisco 878 Point-to-Point
Hello,
We have two Cisco 878 on two side with configured Point-to-Point SHDSL configuration. Also we configured AudioCodes MP114 FXO and MP112 FXS. We using this Point-to-Point SHDSL connection for data and AudioCodes VoIP. AudioCodes MP114 FXO on main office an it connected with Nortel central. We can make a call main to branch or branch to main. But soon after connection of phone calls making with using two AudioCodes is being lost .
AudioCodes Technical Stuff sugested us, you may make QoS configuration with two Cisco 878 for both sides.
First of all, thanks for your configuration. And sorry for I'm late. However I could try this configrution today. But some commands giving error. Outputs are below. My IOS version is c870-advsecurityk9-mz.124-15.T5. I will monitoring Cisco 878 Routers couple days for voice traffic.
What do you think about these?
Best regards,
RTR_MRK_2_C878(config-subif)#service-policy output VoIp
CBWFQ : Not supported on subinterfaces
RTR_MRK_2_C878(config-subif)#
First of all, thanks for your configuration. And sorry for I'm late. However I could try this configrution today. But some commands giving error. Outputs are below. My IOS version is c870-advsecurityk9-mz.124-
What do you think about these?
Best regards,
RTR_MRK_2_C878(config-subi
CBWFQ : Not supported on subinterfaces
RTR_MRK_2_C878(config-subi
RTR_MRK_2_C878(config)#cal
admission Configure Call Admission
RTR_MRK_2_C878(config)#cal