lurezero
asked on
CIsco 2950 L2 Etherchannel
Is there a command that can show me the etherchannel is working properly? This is the output i get but it doesnt tell me (maybe i am ignorant) the speed and the fact that they are operating at 300mbps for example. Anything i can do to test it a different way?
2950#show etherchannel summary
Flags: D - down P - in port-channel
I - stand-alone s - suspended
H - Hot-standby (LACP only)
R - Layer3 S - Layer2
u - unsuitable for bundling
U - in use f - failed to allocate aggregator
d - default port
Number of channel-groups in use: 1
Number of aggregators: 1
Group Port-channel Protocol Ports
------+-------------+----- ------+--- ---------- ---------- ---------- ---------- ----
1 Po1(SU) - Fa0/3(Pd) Fa0/4(P) Fa0/5(P)
2950#show etherchannel summary
Flags: D - down P - in port-channel
I - stand-alone s - suspended
H - Hot-standby (LACP only)
R - Layer3 S - Layer2
u - unsuitable for bundling
U - in use f - failed to allocate aggregator
d - default port
Number of channel-groups in use: 1
Number of aggregators: 1
Group Port-channel Protocol Ports
------+-------------+-----
1 Po1(SU) - Fa0/3(Pd) Fa0/4(P) Fa0/5(P)
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.