Why Experts Exchange?

Experts Exchange always has the answer, or at the least points me in the correct direction! It is like having another employee that is extremely experienced.

Jim Murphy
Programmer at Smart IT Solutions

When asked, what has been your best career decision?

Deciding to stick with EE.

Mohamed Asif
Technical Department Head

Being involved with EE helped me to grow personally and professionally.

Carl Webster
CTP, Sr Infrastructure Consultant
Ask ANY Question

Connect with Certified Experts to gain insight and support on specific technology challenges including:

Troubleshooting
Research
Professional Opinions
Ask a Question
Did You Know?

We've partnered with two important charities to provide clean water and computer science education to those who need it most. READ MORE

troubleshooting Question

Deliver public IP to device through Cisco ASA 5510

Avatar of sadburger
sadburger asked on
Hardware FirewallsServer HardwareTCP/IP
2 Comments1 Solution768 ViewsLast Modified:
I currently have an IP block from my ISP. I am using a Cisco ASA 5510 firewall as the edge device of my network before the ISP router.

We recently purchased a polycom device to allow video conferencing inside our network. It requires a public routable IP be assigned to its WAN interface however, and will not support any sort of NAT/PAT, but I am unsure how to deliver an IP from my block to this device.

I have open ports on my ASA that could be used if needed. My lan side uses standard internal RFC 1918 addresses (192.168.0.0/16), and I have plenty of open IPs on my WAN block, but don't know how to get them to the device.

I have no problems doing incoming PAT or anything like that, but that isn't applicable in this case because it will not work without the public routable IP.
ASKER CERTIFIED SOLUTION
Avatar of foobar_666uk
foobar_666uk

Our community of experts have been thoroughly vetted for their expertise and industry experience.

Commented:
This problem has been solved!
Unlock 1 Answer and 2 Comments.
See Answers