cisco 1841 router


i have configure the sicso router 1841 and at last i have given
copy run start
but when i switched of the router i was nbot able to get the saved config

how to get the saved config

kurajeshSenior Systems AnalystAsked:
Who is Participating?
I wear a lot of hats...

"The solutions and answers provided on Experts Exchange have been extremely helpful to me over the last few years. I wear a lot of hats - Developer, Database Administrator, Help Desk, etc., so I know a lot of things but not a lot about one thing. Experts Exchange gives me answers from people who do know a lot about one thing, in a easy to use platform." -Todd S.

Did you remember to execute a write config before copy run start?

Most common cause of this is someone was recovering the password, and set the config register to 0x2142.  Do a "show ver" and check what the register is.

It should be 0x2102.

To change, simply enter:
config-register 0x2102
copy run star

Or in ROMmon:

confreg 0x2102

Experts Exchange Solution brought to you by

Your issues matter to us.

Facing a tech roadblock? Get the help and guidance you need from experienced professionals who care. Ask your question anytime, anywhere, with no hassle.

Start your 7-day free trial
kurajeshSenior Systems AnalystAuthor Commented:
i have given write mem after copy run start
The Ultimate Tool Kit for Technolgy Solution Provi

Broken down into practical pointers and step-by-step instructions, the IT Service Excellence Tool Kit delivers expert advice for technology solution providers. Get your free copy for valuable how-to assets including sample agreements, checklists, flowcharts, and more!

kurajeshSenior Systems AnalystAuthor Commented:
when i switch off the router and starts it it is loading the default config instead of the saved one, any clue
greg wardSystems EngineerCommented:
Is the configuration register 0x2102
That is the default setting for loading the config file.
It is the last line from show version.
Configuration register is 0x2102
As per the above comments, can you check the config register?

Also, can you issue the "show start" command and see if your config is there?
It's more than this solution.Get answers and train to solve all your tech problems - anytime, anywhere.Try it for free Edge Out The Competitionfor your dream job with proven skills and certifications.Get started today Stand Outas the employee with proven skills.Start learning today for free Move Your Career Forwardwith certification training in the latest technologies.Start your trial today

From novice to tech pro — start learning today.