wwakefield
asked on
SQL 2005 Reporting Services and IIS with Dual NIC
How do I make all Reporting Services / IIS traffic travel over NIC 1 when two NICS are configured?
Setup::
-Windows Server 2003 configured with Dual NICS.
--NIC 1 is 10.10.2.10
--Nic 2 is 10.12.1.10
-Sql Server 2005 with Reporting Services
-IIS is configured
-The Cisco ASA 5510 is configured to allow traffic exchange with 10.10.2.10
SCENARIO: Currently I connect to the ASA with the Cisco client and use the web browser to hit http:\\10.10.2.10\portal.html across that connection. Everything is presented fine and ask for authentication etc. However, when I click one of the internal links, it reflects 10.12.1.10 (Nic 2) on the bottom of the browser instead of 10.10.2.10 (Why the change?). of course this is configured to route outside the Cisco so it fails. we are able to make it work my RDP into the server and executing there since you can hit both NIC from inside the server.
I have edited the two config files to use the Static IP address of NIC 1 instead of the server name, but it still does not work. I did enable NETBIOS over the NIC since I read that might have been an issue (I put it back). The files were rsreporting.config and the web one which I can;t recalll the name at the moment. Would I need to restart the server after I made those changes or is there something else I am missing?
Sincerely,
Setup::
-Windows Server 2003 configured with Dual NICS.
--NIC 1 is 10.10.2.10
--Nic 2 is 10.12.1.10
-Sql Server 2005 with Reporting Services
-IIS is configured
-The Cisco ASA 5510 is configured to allow traffic exchange with 10.10.2.10
SCENARIO: Currently I connect to the ASA with the Cisco client and use the web browser to hit http:\\10.10.2.10\portal.html across that connection. Everything is presented fine and ask for authentication etc. However, when I click one of the internal links, it reflects 10.12.1.10 (Nic 2) on the bottom of the browser instead of 10.10.2.10 (Why the change?). of course this is configured to route outside the Cisco so it fails. we are able to make it work my RDP into the server and executing there since you can hit both NIC from inside the server.
I have edited the two config files to use the Static IP address of NIC 1 instead of the server name, but it still does not work. I did enable NETBIOS over the NIC since I read that might have been an issue (I put it back). The files were rsreporting.config and the web one which I can;t recalll the name at the moment. Would I need to restart the server after I made those changes or is there something else I am missing?
Sincerely,
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Please close.