MoogControls
asked on
Cisco 2960G - Web Management IP
I have a Cisco 2960G switch. It has four VLANs configured as below...
VLAN 1 (default - no ports)
VLAN 100 (management - port 23)
VLAN 210 (various ports 1)
VLAN 220 (various ports 2)
There is no routing between VLANs.
I want to be able to connect via telnet and http to manage the switch on VLAN 220. Currently i can do this using VLAN 100.
This will also involve a change to the management ip address, mask and gateway (currently it is 10.0.0.1 255.255.255.0 and i need to change to to 10.10.0.1 255.255.0.0 10.10.230.1)
What commands to i need to use?
I am a cisco novice at best.
Many Thanks.
VLAN 1 (default - no ports)
VLAN 100 (management - port 23)
VLAN 210 (various ports 1)
VLAN 220 (various ports 2)
There is no routing between VLANs.
I want to be able to connect via telnet and http to manage the switch on VLAN 220. Currently i can do this using VLAN 100.
This will also involve a change to the management ip address, mask and gateway (currently it is 10.0.0.1 255.255.255.0 and i need to change to to 10.10.0.1 255.255.0.0 10.10.230.1)
What commands to i need to use?
I am a cisco novice at best.
Many Thanks.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
could you post your config of the switch?
ASKER
I'm on the same VLAN 220 and have a suitable ip address. Is there anything on the switch that would need enabling other than the ip address setting?