Event Id 1002 - DHCPNack Message
I am getting the following error when i try to assign IP (Through DHCP Server) to my Windows XP Client Systems. Few systems are getting the IP but most of them are not.
Kindly suggest.
"The IP address lease 192.168.2.101 for the Network Card with network address 002100221539 has been denied by the DHCP server 0.0.0.0 (The DHCP Server sent a DHCPNACK message)."
Kindly suggest.
"The IP address lease 192.168.2.101 for the Network Card with network address 002100221539 has been denied by the DHCP server 0.0.0.0 (The DHCP Server sent a DHCPNACK message)."
ASKER
I am working on a newly build laptop having windows XP. It doesnt assign the DHCP so Release and renew doesnt work on this ..
I am using a software called MacFilterCallOutInstaller.
The server is not showing any error but the systems show the mentioned error everytime i try to assign the DHCP.
Please Suggest
I am using a software called MacFilterCallOutInstaller.
The server is not showing any error but the systems show the mentioned error everytime i try to assign the DHCP.
Please Suggest
did you configure the tool MacFilterCallou... to accept dhcp request from mac adres: 002100221539?
I don't know about this tool, maybe you can uninstall it and test if this tool is the cause of your problem?
I don't know about this tool, maybe you can uninstall it and test if this tool is the cause of your problem?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
The IP address for this computer is the same IP address used by another computer on the network. No user action is required. The DHCP client will attempt to get a new IP address from the DHCP server.
To perform these procedures, you must be a member of the Administrators group, or you must have been delegated the appropriate authority.
If you do not want to wait for the client to make its automatic renewal attempt, you can manually release and renew the IP address of the client by following these steps:
1.At the DHCP-enabled client computer, click Start, in Start Search type cmd, and then press ENTER.
2.Type ipconfig /release, and then press ENTER.
3.Type ipconfig /renew, and then press ENTER.
Verify
To verify that address conflicts have been resolved:
1.At the DHCP-enabled client computer, click Start, in Start Search type cmd, and then press ENTER.
2.To verify a DHCP client lease, type ipconfig /all to view lease-status information.
3.The output of the ipconfig command should show an IPv4 or IPv6 address marked "preferred."