Cisco 2811 - Dual Internet Connection - Route-Maps

Hi there,

I appreciate that this question has probably been asked before, however I didn't see one based on my particular set of circumstances.  

I have a 2811 with 2 HWIC-1ADSL-M and 2 Switch modules, HWIC-D-9ESW and a NM-16ESW.
I understand and can implement route-maps on my 1760 & 2950 combination, this isn't the issue, the issue is that the route-map policy is normally applied to the Lan side interface (from what I see normally from a switch uplink) however my 2811 has switch modules I would prefer to use than reinventing the wheel by hanging a switch off the 2811.

If someone can point me in the right direction regarding (maybe include a sample config) my problem, it would be greatly appreciated.

Many Thanks
BananaskinAsked:
Who is Participating?
I wear a lot of hats...

"The solutions and answers provided on Experts Exchange have been extremely helpful to me over the last few years. I wear a lot of hats - Developer, Database Administrator, Help Desk, etc., so I know a lot of things but not a lot about one thing. Experts Exchange gives me answers from people who do know a lot about one thing, in a easy to use platform." -Todd S.

GJHopkinsCommented:
The switch ports will normally be connected to a VLAN interface, you can policy route traffic coming into that vlan interfce thus

access-list 100 permit ip host 10.10.10.1 any
access-list 101 permit ip host 10.10.10.2 any


route-map set-interface permit 10
 match ip address 101
 set interface Dialer0

route-map set-interface permit 20
 match ip address 102
 set interface Dialer1

interface vlan 1
 ip add 10.10.10.254 255.255.255.0
 ip policy route-map set-interface


see also

http://www.cisco.com/en/US/docs/ios/12_2/qos/configuration/guide/qcfpbr_ps1835_TSD_Products_Configuration_Guide_Chapter.html#wp1001019

for more examples
0

Experts Exchange Solution brought to you by

Your issues matter to us.

Facing a tech roadblock? Get the help and guidance you need from experienced professionals who care. Ask your question anytime, anywhere, with no hassle.

Start your 7-day free trial
GJHopkinsCommented:
Sorry - the access lists should of course match the route map so 101 and 102 :-(
0
BananaskinAuthor Commented:
GJ Hopkins,
I am assuming that I would be applying "ip nat inside" to the Vlan Interface?

0
GJHopkinsCommented:
Correct, you'd need NAT access lists etc and the VLAN interface will be inside and both the dialer interfaces outisde.
0
It's more than this solution.Get answers and train to solve all your tech problems - anytime, anywhere.Try it for free Edge Out The Competitionfor your dream job with proven skills and certifications.Get started today Stand Outas the employee with proven skills.Start learning today for free Move Your Career Forwardwith certification training in the latest technologies.Start your trial today
Routers

From novice to tech pro — start learning today.