Cisco 2811 - NM-16ESW and HWIC-D-9ESW

Guys,

This is probably an easy one for you experts.

I have a 2811 with two switch modules, NM-16ESW and HWIC-D-9ESW.  When I attach any network device to the HWIC-D-9ESW there are no problems, ip's are assigned from my DHCP server etc, on the other hand when anything is plugged into any of the ports on the NM-16ESW, I can see that the port has come up on the I/F and through the console, but no data/packets etc are being relayed so no ip's assigned etc.

The router config is basic at the moment as I am migrating from two 1760's/2950 to the 2811 using route-maps (2 x ISPS).

So all the switch ports are configured with - Spanning-tree portfast

Fas0/0 and 0/1 are set for ethernet modems (1 static and dynamic)
Vlan 1 is ip 192.168.1.200 with ip route-map policy assigned.

Is this a simple issue, can the two switch modules co-exist, do they need to be bonded.

Help is very much appreciated

Many Thanks.
BananaskinAsked:
Who is Participating?

[Webinar] Streamline your web hosting managementRegister Today

x
 
BananaskinConnect With a Mentor Author Commented:
I think I found the answer, allbeit, not the one I wanted, apparently the stacking or linking of the two switch modules can only be done if each module has a gig uplink port, which none of these switch modules have.

https://supportforums.cisco.com/message/526785;jsessionid=B55C65EAD688124FDD89444C15929BD7.node0?tstart=-3

If anyone else has a solution that contradicts this, it would be appreciated.
Regards
0
 
Istvan KalmarHead of IT Security Division Commented:
Please show the whole config...
0
 
BananaskinAuthor Commented:
ikalmar,
I think I know what you are looking for, stacking-partner config on two interfaces, if that is the case, I already tried from fas0/3/8 (HWIC-D-9ESW) to fas1/0 (NM-16ESW) with the result below:
2811-DSL(config-if)#switchport stacking-partner interface fastEthernet 1/0
Command reject: Interface FastEthernet1/0 is not capable for stacking, e.g., routed port.

Below is the porton of my running-config relating to I/F's etc.

!
interface FastEthernet0/0
 description PIPEX ADSL Link
 ip address xx.xxx.xxx.xx 255.255.255.0
 ip nat outside
 ip virtual-reassembly
 no ip route-cache
 duplex auto
 speed auto
 no mop enabled
!
interface FastEthernet0/1
 description SKY ADSL Link
 ip address dhcp
 ip nat outside
 ip virtual-reassembly
 no ip route-cache
 duplex auto
 speed auto
 no mop enabled
!
interface FastEthernet0/3/0
 switchport access vlan 2
 carrier-delay msec 0
 spanning-tree portfast
!
interface FastEthernet0/3/1
 switchport access vlan 2
 carrier-delay msec 0
 spanning-tree portfast
!
interface FastEthernet0/3/2
 switchport access vlan 2
 carrier-delay msec 0
 spanning-tree portfast
!
interface FastEthernet0/3/3
 switchport access vlan 2
 carrier-delay msec 0
 spanning-tree portfast
!
interface FastEthernet0/3/4
 switchport access vlan 2
 carrier-delay msec 0
 spanning-tree portfast
!
interface FastEthernet0/3/5
 switchport access vlan 2
 carrier-delay msec 0
 spanning-tree portfast
!
interface FastEthernet0/3/6
 switchport access vlan 2
 carrier-delay msec 0
 spanning-tree portfast
!
interface FastEthernet0/3/7
 switchport access vlan 2
 carrier-delay msec 0
 spanning-tree portfast
!
interface FastEthernet0/3/8
 switchport access vlan 2
 carrier-delay msec 0
 spanning-tree portfast
!
interface ATM0/0/0
 no ip address
 no ip route-cache
 shutdown
 no atm ilmi-keepalive
 dsl operating-mode auto
!
interface ATM0/1/0
 no ip address
 no ip route-cache
 shutdown
 no atm ilmi-keepalive
 dsl operating-mode auto
!
interface FastEthernet1/0
 switchport access vlan 2
 carrier-delay msec 0
 power inline never
 spanning-tree portfast
!
interface FastEthernet1/1
 switchport access vlan 2
 carrier-delay msec 0
 power inline never
 spanning-tree portfast
!
interface FastEthernet1/2
 switchport access vlan 2
 carrier-delay msec 0
 power inline never
 spanning-tree portfast
!
interface FastEthernet1/3
 switchport access vlan 2
 carrier-delay msec 0
 power inline never
 spanning-tree portfast
!
interface FastEthernet1/4
 switchport access vlan 2
 carrier-delay msec 0
 power inline never
 spanning-tree portfast
!
interface FastEthernet1/5
 switchport access vlan 2
 carrier-delay msec 0
 power inline never
 spanning-tree portfast
!
interface FastEthernet1/6
 switchport access vlan 2
 carrier-delay msec 0
 power inline never
 spanning-tree portfast
!
interface FastEthernet1/7
 switchport access vlan 2
 carrier-delay msec 0
 power inline never
 spanning-tree portfast
!
interface FastEthernet1/8
 switchport access vlan 2
 carrier-delay msec 0
 power inline never
 spanning-tree portfast
!
interface FastEthernet1/9
 switchport access vlan 2
 carrier-delay msec 0
 power inline never
 spanning-tree portfast
!
interface FastEthernet1/10
 switchport access vlan 2
 carrier-delay msec 0
 power inline never
 spanning-tree portfast
!
interface FastEthernet1/11
 switchport access vlan 2
 carrier-delay msec 0
 power inline never
 spanning-tree portfast
!
interface FastEthernet1/12
 switchport access vlan 2
 carrier-delay msec 0
 power inline never
 spanning-tree portfast
!
interface FastEthernet1/13
 switchport access vlan 2
 carrier-delay msec 0
 power inline never
 spanning-tree portfast
!
interface FastEthernet1/14
 switchport access vlan 2
 carrier-delay msec 0
 power inline never
 spanning-tree portfast
!
interface FastEthernet1/15
 switchport access vlan 2
 carrier-delay msec 0
 power inline never
 spanning-tree portfast
!
interface Vlan1
 no ip address
 ip nat inside
 ip virtual-reassembly
 no ip route-cache
 ip policy route-map ADSL
!
interface Vlan2
 ip address xxx.xxx.x.xxx 255.255.255.0
 ip nat inside
 ip virtual-reassembly
 no ip route-cache
 ip policy route-map ADSL
!

0
All Courses

From novice to tech pro — start learning today.