OpsView Remote monitoring

I have an OpsView server running that monitors our local and remote networks. I was asked to monitor 3 servers from a single nat'd address. I was suuccessful in getting nrpe working for the three boxes, but I can't seem to get the snmp monitoring to work, the three servers have ports 171,172,173 nat'd to port 161 on each of the three boxes
hoshie329Asked:
Who is Participating?
 
Cyclops3590Commented:
By default the snmp probe will use 161. Been awhile since I used opsview so I can't remember if you can override the client itself or not. I don't believe you can. I'm pretty sure you will have to create custom snmp probes so they use the required port you need
0
 
Cyclops3590Commented:
Obviously there was participation, please give a comment back
0
 
Cyclops3590Commented:
Obviously there was participation, please give a comment back
0
 
hoshie329Author Commented:
ok
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.