How to configure cisco 2811 Router with VWIC E1 and 2 FXO and 2 FXS module for PSTN Simulation

Hi,

I want to configure one Cisco 2811 Router for my CCVP Voice LAB as PSTN Service Provider .which can provide me2  E1 line with 8 Chanels  and FXO ports to connet my Home Telephone lIne so I can call outside with my phone FXS to simulate International and local Tel numbers.

it will be provoding E1 Chennels to my Head office and Branch Office
You can say as PSTN Exchange .

gukhanAsked:
Who is Participating?
 
hus1984Connect With a Mentor Commented:
if you want E1 PRI here is the configuration:
card type E1 0(slot number) 0(wic number)
network-clock-participate wic 0
controller e1 0/0
pri-group timeslots 1-8

then start using dial-peers for FXO and FXS normally as you want

Hussam

0
 
lrmooreConnect With a Mentor Commented:
If you are setting this up for your CCVP lab, then you have to at least already have a basic understanding of what you need to do. If you get stuck and need help on a specific issue, please post a very specific question. This question is so broad, it's like asking "how do I make a clock" when you really  just need to know what time it is.
0
 
gukhanAuthor Commented:
ok
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.